Village of Lynbrook (NY)

New York Authority Having Jurisdiction Solar permitting requirements

NEC Code Version2023

Wet Stamps RequiredDigital Structural,Digital Electrical

Fire Setback Enforced0

Codes

NEC Code Version: 2023

Code List

2025 NEW YORK STATE BUILDING CODE

2025 NEW YORK STATE RESIDENTIAL CODE

2025 NEW YORK STATE FIRE CODE

2025 NEW YORK STATE ENERGY CONSERVATION CODE

2025 NEW YORK STATE EXISTING BUILDING CODE

2025 NEW YORK STATE FUEL GAS CODE

2025 NEW YORK STATE MECHANICAL CODE

2025 NEW YORK STATE PLUMBING CODE

2025 NEW YORK STATE ENERGY STANDARD FOR SITES AND BUILDINGS EXCEPT LOW-RISE RESIDENTIAL BUILDINGS

2023 NATIONAL ELECTRICAL CODE

ASCE Code Specification: ASCE 7-16

SolarAPP+ & submittal

How Many Plansets Required: 2

Revision Required: 0

New Planset Required For Module Swap: 0

Stamps

Ee Stamp Required On SLD: Yes

Wet Stamps Required: Digital Structural,Digital Electrical

Structural Calculations Required: Yes

Stamp Location On Plans: Unspecified

Date On Stamps: Expiration Date

Fire setbacks

Fire Setback Enforced: 0

Setback Notes: Standard

Structural & loads

Wind Speed: 85

Snow Load: 999

Reducible Snow Load Allowed: 1

Max Attachment Spacing: 96

Minimum Ground On Roof: #10

Electrical

Allowed POI: PV Breaker,Line Side Taps,Meter Adapter,Load Side Taps

Panel Schedule Required: Partial Home Backup

Temperature Rating: 90

De Rating Ampacity: 0.91

Battery / ESS

Unique Battery Placards Needed: 0

ESS Notes: Standard

Separate ESS Disconnect Required: ESS Disconnect

ESS Elevation Detail Required: No

Plan set

Plan Set Requirements: Plans must include color renderings of the panels superimposed on the home - along with color pictures of the front/side/rear of home. Conduit location to be shown in dark color on renderings. Specify that the panels cannot be seen from the street. Conduit must be shown in different colors for roof jumpers and DC conduit to inverter. (Blue for DC roof pipe, yellow for DC homerun to INV)

Site: Conduit will need to be show on the site plan.

Roof Plan: Panels may not be placed on either the front of house or where they can be seen from the street, unless there is an exception (i.e. house on dead-end street surrounded by commercial buildings).

Attachment Detail: Please be advised this AHJ requires a mandatory architectural review board meeting ; panel placement is very important. With that, please try to avoid the front facing roof of home, especially if they can be seen from street. If corner house be mindful of the two sides of roof that face the street ; same applies to avoid panels being visible from street. Highly unlikely any project where panels are visible from street, especially on front, will be approved for permit.

Custom Placards Required: 0

Ground mount

Ground Mount Fencing Required: Mesh/Scrim