City of Midvale City (UT)

Utah Authority Having Jurisdiction Solar permitting requirements

NEC Code Version2020

Fire Code Version2018 Building Code

Wet Stamps RequiredDigital Structural

Fire Setback Enforced1

Codes

NEC Code Version: 2020

Fire Code Version: 2018 Building Code

Code List: 2021 INTERNATIONAL BUILDING CODE 2021 INTERNATIONAL ENERGY CONSERVATION CODE 2021 INTERNATIONAL FIRE CODE 2021 INTERNATIONAL FUEL GAS CODE 2021 INTERNATIONAL MECHANICAL CODE 2021 INTERNATIONAL PLUMBING CODE 2021 INTERNATIONAL RESIDENTIAL CODE 2020 NATIONAL ELECTRICAL CODE

ASCE Code Specification: ASCE 7-16

SolarAPP+ & submittal

How Many Plansets Required: 1

Revision Required: 0

New Planset Required For Module Swap: 0

Stamps

Wet Stamps Required: Digital Structural

Structural Calculations Required: Yes

Stamp Location On Plans: Unspecified

Date On Stamps: Expiration Date

Fire setbacks

Fire Setback Enforced: 1

Setback Notes: Standard

Structural & loads

Wind Speed: 115

Wind Notes: Exposure Category C

Snow Load: 30

Reducible Snow Load Allowed: 1

Max Attachment Spacing: 96

Structural Notes: 2020 NEC, 2021 IBC 2021 IRC (ON STRUCTURAL CALS )

Minimum Ground On Roof: #10

Electrical

Electrical Load Calcs Required: Derates

Allowed POI: PV Breaker,Meter Adapter,Line Side Taps,Load Side Taps

Panel Schedule Required: Partial Home Backup

Temperature Rating: 90

De Rating Ampacity: 0.96

Battery / ESS

Unique Battery Placards Needed: 0

ESS Notes: Standard

Separate ESS Disconnect Required: ESS Disconnect

ESS Elevation Detail Required: No

Plan set

Plan Set Requirements: Utah does not want single panel arrays with railless systems. Please have layout changed if this happens example photo below

Roof Plan: * #6 awg minimum rooftop wire size

Attachment Detail: No single panel arrays

Electrical Diagram: _**All Jobs:**_ * Pictures of the main service panel and utility meter are required _ **MPUs:**_ * MSP model number is required for all MPU's * The new service panel MUST be a type where there is only ONE MAIN breaker that shuts off all other breakers. The new service panel CANNOT be a type which has additional breaker slots fed directly from the utility meter (i.e., cannot install a “hot bus” service panel * IF the existing service panel (shown in the provided photos) will be reused as a sub-panel, please note this on the plans and add the following note to the line diagram: “An equipment grounding conductor must be provided from the new service panel to the old service panel and all neutrals must be isolated from grounds at the old service panel"

Label Page: Rapid shutdown is to be pointed at the main service panel, not the inverter.

Label Page Notes: all signage must be permanently attached and be weather resistant/sunlight resistant and cannot be hand-written. NEC 110.21(B)

Custom Placards Required: 0

Ground mount

Ground Mount Fencing Required: Mesh/Scrim